Filter
Top Products
119
Dialogic
®
DSI SS7MD Programmer’s Manual Issue 3
7.1.1 SS7_BOARD – Configure Dialogic
®
DSI SS7MD Network Interface Board
Synopsis
Command to configure a DSI SS7MD Board in the system.
Syntax
SS7_BOARD <board_id> <board_type> <flags> <code_file> <run_mode>
Example
SS7_BOARD 0 SS7MD 0x0000 ss7.dc6 LSL
Parameters
The SS7_BOARD command includes the following parameters:
• <board_id>
The logical identity of the board in the range from 0 to one less than the number of boards supported
(typically, 0 to 3).
• <board_type>
The board type within the system. Possible values are:
—SS7MD – for DSI SS7MD Boards
• <flags>
A 16-bit value that provides additional level 1 configuration for the board. The meaning of each bit may
vary with different board types. The bits have the following significance:
— Bit 0 is set to 1 to recover the clock from the LIU; 0 use internal clock
— All other bits are reserved and should be set to 0.
• <code file>
The name of the codefile that gets downloaded to the board when it is reset. Codefiles for DSI SS7MD
Boards use the suffix .dc6.
• <run_mode>
The protocols to be run. The following table shows the permitted values and their meanings.
7.1.2 LIU_CONFIG – Configure a T1/E1/J1 LIU
Synopsis
This command is used during initialization to configure the operating parameters for a T1/E1/J1 Line
Interface Unit (LIU).
Syntax
LIU_CONFIG <board_id> <liu_id> <liu_type> <line_code> <frame_format> <crc_mode> [<build_out>]
Example
LIU_CONFIG 0 051110
Parameters
The LIU_CONFIG command includes the following parameters:
Feature
<run mode>
LSL HSL ATM IMA
Low Speed Links xxx
High Speed Links xxx
ATM links xxx
Multiple ATM links in IMA bundles xx