Filter
Top Products
148
7 Configuration Command Reference
7.7.3 SCCP_CONC_SSR – SCCP Concerned Sub-System Resource
Synopsis
The SCCP_CONC_SSR command marks the specified sub-system (which was declared by SCCP_SSR) as
requiring notification of changes in the accessibility of another sub-system. Notification is given in the form
of an SCCP management indication.
Syntax
SCCP_CONC_SSR <id> <cssr_id> <ssr_id>
Example
SCCP_CONC_SSR 1 2 3
Parameters
The SCCP_CONC_SSR command includes the following parameters:
• <id>
A unique ID.
• <cssr_id>
The ID of the subsystem that will receive the notifications.
• <ssr_id>
The ID of the sub-system for which state changes will be issued.
7.7.4 SCCP_TRACE – SCCP Trace
Synopsis
The SCCP_TRACE command is used to configure SCCP to send trace messages to the trace module whenever
a specific message type is sent or received. See the SCCP Programmer’s Manual for details.
Syntax
SCCP_TRACE <op_evt_mask> <ip_evt_mask> <non_prim_mask>
Example
SCCP_TRACE 0x1 0x1 0x1
Parameters
The SCCP_TRACE command includes the following parameters:
• <op_evt_mask>
Output event trace mask.
• <ip_evt_mask>
Input event trace mask.
• <non_prim_mask>
Non-primitive trace mask.