Filter
Top Products
DGS-3024 Gigabit Ethernet Switch Manual
Figure 7- 6. Example of Port Trunk Group
The Switch treats all ports in a trunk group as a single port. Data transmitted to a specific host (destination address) will
always be transmitted over the same port in a trunk group. This allows packets in a data stream to arrive in the same order
they were sent.
NOTE: If any ports within the trunk group become disconnected, packets
intended for the disconnected port will be load shared among the other
uplinked ports of the link aggregation group.
Link aggregation allows several ports to be grouped together and to act as a single link. This gives a bandwidth that is a
multiple of a single link's bandwidth.
Link aggregation is most commonly used to link a bandwidth intensive network device or devices, such as a server, to the
backbone of a network.
The Switch allows the creation of up to four link aggregation groups, each group consisting of 2 to 8 links (ports). The
aggregated links must be contiguous (they must have sequential port numbers) except the two (optional) Gigabit ports, which
can only belong to a single link aggregation group. All of the ports in the group must be members of the same VLAN, and
their STP status, static multicast, traffic control, traffic segmentation and 802.1p default priority configurations must be
identical. Port locking, port mirroring and 802.1x must not be enabled on the trunk group. Further, the aggregated links must
all be of the same speed and should be configured as full duplex.
The Master Port of the group is to be configured by the user, and all configuration options, including the VLAN
configuration that can be applied to the Master Port, are applied to the entire link aggregation group.
Load balancing is automatically applied to the ports in the aggregated group, and a link failure within the group causes the
network traffic to be directed to the remaining links in the group.
The Spanning Tree Protocol will treat a link aggregation group as a single link, on the Switch level. On the port level, the
STP will use the port parameters of the Master Port in the calculation of port cost and in determining the state of the link
aggregation group. If two redundant link aggregation groups are configured on the Switch, STP will block one entire group,
in the same way STP will block a single port that has a redundant link.
29