Filter
Top Products
DGS-3024 Gigabit Ethernet Switch Manual
To configure port trunking, click on the Link Aggregation hyperlink in the Configuration folder to bring up the following
window:
Figure 7- 7. Port Trunking Group window
To configure port trunk groups, click the Add button to add a new trunk group and use the Port Trunking Configuration
window to set up trunk groups. To modify a port trunk group, click the Modify button corresponding to the entry you wish
to alter. To delete a port trunk group, click the corresponding
under the Delete heading in the Current Trunking Group
Entries table.
Figure 7- 8. Port Trunking Configuration window
The user-changeable parameters are as follows:
Parameter Description
Group ID [1-4]
Select an ID number for the group, between 1 and 4.
State
Trunk groups can be toggled between Enabled and Disabled. This is used to turn a
port trunking group on or off. This is useful for diagnostics, to quickly isolate a
bandwidth intensive network device or to have an absolute backup aggregation
group that is not under automatic control.
Type
The type of port trunking supported by the DGS-3024 is Static.
30