Filter
Top Products
DGS-3024 Gigabit Ethernet Switch Manual
True.
State
This drop-down menu allows you to enable or disable STP for the selected group of
ports. The default is Enabled.
Click Apply to implement changes made.
Forwarding
Unicast Forwarding
Open the Forwarding folder in the Configuration menu and click on the Unicast Forwarding link. This will open the
Setup Static Unicast Forwarding Table window, as shown below:
Figure 7- 26. Setup Static Unicast Forwarding Table window
To add or edit an entry, define the following parameters and then click Add/Modify:
Parameter Description
VID (VLAN ID)
The VLAN ID number of the VLAN on which the above Unicast MAC address
resides.
MAC Address
The MAC address to which packets will be statically forwarded. This must be a
unicast MAC address.
Allowed to go port
Allows the selection of the port number on which the MAC address entered above
resides.
Click Apply to implement the changes made. To delete an entry in the Static Unicast Forwarding Table, click the
corresponding
under the Delete heading.
Multicast Forwarding
The following window describes how to set up Multicast Forwarding on the Switch. Open the Forwarding folder and click
on the Multicast Forwarding link to see the entry window below:
48