Filter
Top Products
5 Configuration D-Link Web Smart Switch User Manual
The setting
s of IGMP snooping is set by each VLAN individually.
Figure 5.43 – L2 Functions > Multicast > IG
MP Snooping
By default, IGMP is disabled. If enabled, the IGMP Global Settings will need to be entered:
Host Timeout (130-153025 sec): This is the interval after which a learned host port entry will be purged. For
each host port learned, a 'Port Purge Timer' runs for 'Host Port Purge Interval'. This timer will be restarted
whenever a report message from host is received over that port. If no report messages are received for 'Host
Port Purge Interval' time, the learned host entry will be purged from the multicast group. The default value is
260 seconds.
Robustness Variable (2-255 sec): The Robustness Variable allows adjustment for the expected packet loss
on a subnet. If a subnet is expected to be lossy, the Robustness Variable may need to be increased. The
Robustness Variable cannot be set to zero, and it SHOULD NOT be. Default is 2 seconds.
Query Interval (60-600 sec): T eral Queries sent. By adjusting
the Query Interval, the number of larger values will cause
outer Timeout (60-600 sec): This is the interval after which a learned router port entry will be purged. For
server is notified that there are no more
he Query Interval is the interval between Gen
IGMP messages can be increased or decreased;
IGMP Queries to be sent less often. Default value is 125 seconds.
R
each router port learned, a 'Router Port Purge Timer' runs for 'Router Port Purge Interval'. This timer will be
restarted whenever a Query control message is received over that port. If there are no Query control
messages received for 'Router Port Purge Interval' time, the learned router port entry will be purged. Default
is 260 seconds.
Last Member Query Interval (1-25 sec): The Last Member Query Interval is the Max Response Time
inserted into Group-Specific Queries sent in response to Leave Group messages, and is also the amount of
time between Group-Specific Query messages. This value may be adjusted to modify the "leave latency" of
the network. A reduced value results in reduced time to detect the loss of the last member of a group. Default
is 1 second.
Max Response Time (10-25 sec): The Max Response Time specifies the maximum allowed time before
sending a responding report message. Adjusting this setting effects the "leave latency", or the time between
the moment the last host leaves a group and when the multicast
members. It also allows adjustments for controlling the frequency of IGMP traffic on a subnet. Default is 10
seconds.
To enable IGMP snooping for a given VLAN, select enable and click on the Apply button. Then press the
VLAN ID number under IGMP Snooping VLAN Setting, and select the State, Querier State and Fast Leave
to be enabled or disabled, and the ports to be assigned as router ports for IGMP snooping for the VLAN.
Press Apply for changes to take effect. A router port configured manually is a Static Router Port, and a
Dynamic Router Port is dynamically configured by the Switch when a query control message is received.
4
4
1
1