Filter
Top Products
5 Configuration D-Link Web Smart Switch User Manual
LLDP: When this
function is Enabled, the switch can start to transmit, receive and process the LLDP packets.
es the actual TTL value
eter indicates the interval at which LLDP frames are transmitted
mount of delay from the time adminStatus
cessive LLDP frame
2 Functions > LLDP > LLDP MED Settings
For the advertisement of LLDP packets, the switch announces the information to its neighbor through ports.
For the receiving of LLDP packets, the switch will learn the information from the LLDP packets advertised
from the neighbor in the neighbor table. Click Apply to make the change effective.
Message TX Hold Multiplier (2-10): This parameter is a multiplier that determin
used in an LLDPDU. The default value is 4.
Message TX Interval (5-32768): This param
on behalf of this LLDP agent. The default value is 30 seconds.
LLDP ReInit Delay (1-10): This parameter indicates the a
becomes "disabled" until re-initialization is attempted. The default value is 2 seconds.
LLDP TX Delay (1-8192): This parameter indicates the delay between suc
transmissions initiated by value or status changes in the LLDP local systems MIB. The value for txDelay is
set by the following range formula: 1 < txDelay < (0.25 °— msgTxInterval). The default value is 2 seconds.
L
To Port), the power PSE TLV type can be enabled for all By selecting a range of ports (From Port and
selected ports to indicate the power source equipment (PSE) switch to transmit high power (15.4 to 30 Watts)
to the pre-standard of 802.3at power devices via LLDP MDI TLV. Through this feature, the PSE can provide
precise output power to the pre-standard of 802.3at power devices and achieve optimal power management.
Figure 5.51 – L2 Functions > LLDP > LLDP MED Settings
2 Functions > LLDP > LLDP Port SettingsL
LDP port information and contains parameters for configuring The Basic LLDP Port Settings page displays L
LLDP port settings.
Figure 5.52 – L2 Functions > LLDP > LLDP Port Settings
rom Port/ To Port: A consecutive group of ports may be configured starting with the selected port.
he port.
DP notification on the port.
This is the default value.
dmin values are:
LDP packets. This is the default.
F
Notification State: Specifies whether notification is sent when an LLDP topology change occurs on t
The possible field values are:
Enabled – Enables LL
Disabled – Disables LLDP notification on the port.
A Status: Specifies the LLDP transmission mode on the port. The possible field
TX_Only – Enables transmitting LLDP packets only.
RX_Only – Enables receiving LLDP packets only.
TX_and_RX – Enables transmitting and receiving L
4
4
5
5