Filter
Top Products
43
Maintenance and Cleaning
Lamp Replace Counter
Be sure to reset the lamp replace counter after Lamp Assembly is replaced. When the lamp replace counter is reset, the
LAMP REPLACE Indicator stops lighting.
Note :
–Do not reset the Lamp Replace Counter until after the projection lamp is replaced.
Turn projector on, press the MENU button to display the
On-Screen Menu. Press the Point
7 8 buttons to move the
red frame pointer to the Setting Menu icon.
Press the Point d button to move the red frame pointer to
“Lamp counter reset” and then press
the SELECT button.
The message " Lamp replace counter reset? " is displayed.
Move the pointer to [Yes] and then press the SELECT
button.
1
2
Another confirmation dialog box appears and select [Yes] to
reset the lamp replace counter.
3
This projector uses a high-pressure lamp which must be handled carefully and properly. Improper handling may
result in an accidents, injury, or create a fire hazard.
● Lamp lifetime may differ from lamp to lamp and according to the environment of use. There is no guarantee of
the same lifetime for each lamp. Some lamps may fail or terminate their lifetime in a shorter period of time than
other similar lamps.
● If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE INDICATOR lights up,
replace the lamp with a new one IMMEDIATELY after the projector has cooled down.
( Follow carefully the instructions in the LAMP REPLACEMENT section of this manual. ) Continuous use of the
lamp with the LAMP REPLACE INDICATOR lighted may increase the risk of lamp explosion.
● A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its lifetime draws
to an end. Risk of explosion may differ according to the environment or conditions in which the projector and
lamp are being used.
IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.
If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immediately. Contact an authorized
service station for a checkup of the unit and replacement of the lamp. Additionally, check carefully to ensure that
there are no broken shards or pieces of glass around the projector or coming out from the cooling air circulation
holes. Any broken shards found should be cleaned up carefully. No one should check the inside of the projector
except those who are authorized trained technicians and who are familiar with projector service. Inappropriate
attempts to service the unit by anyone, especially those who are not appropriately trained to do so, may result in an
accident or injury caused by pieces of broken glass.
LAMP HANDLING PRECAUTIONS
Move the pointer to Lamp counter reset and then
press the SELECT button. The message “Lamp
replace counter reset?” is displayed.
Maintenance & Cleaning
Setting Menu icon