Filter
Top Products
Running the Navis
phere Storage System Initialization Utility
You can start the s
torage system initialization utility from the server
on which it is inst
alled or from the server support CD. The storage
system initializ
ation utility has two methods for executing commands
— a command line i
nterface that can be scripted, or a text-based utility
that cannot be sc
ripted.Beforecontinuingmakesurethatthestorage
system is power
ed up completely.
Note: Before using the Navisphere Storage System Initialization Utility, make
sure that you know the static IP addresses for the storage system SPs (for
example, http://123.45.6.7 and 123.45.6.8), the subnet mask, and the default
gateway address. For storage system initialization, connect the server from
which you are running the utility and the storage system to the same network
subnet, Once you have assigned an IP address to the storage system, the server
and storage system can be on different subnets.
Starting and u
sing the storage system initialization utility on a Solaris server
This section describes the supported methods for starting and using the
storage system initialization utility.
Starting the initialization utility from a server
To start the text-based or command line utility from a server , enter:
/opt/Navisphere/bin/naviinittool and for the command line utility,
include any of the command line switches in Using the command line
initialization utility, page 15.
Starting the initialization utility from the CD
To start the text-based or command line utility from the CD, do the
following:
1. At the Solaris server, log in as superuser (root).
2. In the server’s drive, insert the server support CD, which shipped
with the storage system or the upgrade kit (for AX-series systems
upgrading to Navisphere Manager).
3. Navigate to the Solaris directory:
12
EMC CLARiiON Server Support Products for Solaris Server Installation Guide