Filter
Top Products
Parameter Description
Storage Processor B - IP
ADDRESS
IP address for SP B management port. For a
CX3–series system, this IP address cannot be
128.221.1.250, 128.221.1.251,192.168.1.1, or
192.168.1.2 because these addresses are reserved.
For an AX-series storage system, this IP address
cannot be 192.168.1.1 or 192.168.1.2 because these
addresses are reserved.
Subnet Mask Subnet mask associated with the LAN to which the
storage-system management port is connected.
Default Gateway Default gateway address for the LAN to which the
storage-system management port is connected.
4. Enter the name you want for the storage system; it cannot exceed
32 characters.
5. When you have set the parameters to the values you want, apply
the values by typing a.
6. Using the information in the “Storage-System Management
Ports” worksheet from the storage-system configuration planning
guide, planning worksheets document, or the “Administration
Worksheet”, follow the instructions on the screen to change
the storage system’s name, if desired, and to set the following
management user account settings for the storage system:
7. When you have set the parameters to the values you want, apply
the values by typing a.
8. Exit the utility by typing e.
For a CX3-series storage system
If you entered an SP IP address for the first time or changed an SP IP
address, the utility reboots the storage system, and the SP fault light on
the back of each SP starts blinking. The reboot takes several minutes
to complete. When it is completed, the SP fault light (LEDs) on each
SP stops blinking and remains off.
For an AX-series storage system
If you entered an SP IP address for the first time or changed an SP IP
address, the utility reboots the storage system and the SP Boot/Fault
light on the back of each SP starts blinking. The reboot takes several
minutes to complete. When it is completed, the SP Boot/Fault light on
each SP stops blinking and remains off.
14
EMC CLARiiON Server Support Products for Solaris Server Installation Guide