Filter
Top Products
Installing or rem
oving the Navisphere Host Agent and CLI
You can install bo
th the host agent and CLI package or just the CLI
package. If you wi
ll install both, install the host agent first.
To modify an exist
ing host agent configuration refer to the next section.
Note: If you want to install the host agent and use some of the features in
the server utility, see Determining whether to install the host agent or server
utility,
page 17.
Installing the ho
st agent and/or CLI on a Solaris server
EMC recommends that you install the most recent version of the
Navisphere Host Agent/ CLI software that is appropriate for your
configuration. You can download the most recent version from either
the software download page on the Powerlink website (CX3–series and
CX-series) or on the support website (AX-series storage systems). You
can also install the software from the server support CD (any storage
system); however, the CD may not contain the most recent version for
your configuration.
1. If you are installing the host agent, make sure that each storage
system is connected to the Solaris server where you are installing
the host agent.
2. At the Solaris server, log in as superuser (root).
3. If any previous revision of the host agent/CLI is installed on the
server, remove it before continuing.
Note: To verify if a previous version is installed, enter the pkginfo |grep
HOST command.
4. To download the software for CX3–series or CX-series storage
systems, do the following:
a. On the Powerlink website, select Support > Software
Downloads and Licensing and navigate to the CLARiiON
Navisphere Host Agent/ CLI download section for Solaris.
22
EMC CLARiiON Server Support Products for Solaris Server Installation Guide