Filter
Top Products
1
Configuring the IP Address
1-5
Setting the Initial Switch Configuration
Configuring the IP Address
The Departmental Switch DS-16B2 switch is shipped with a default
IP address of
10.77.77.77.
To change the default IP Address and configure the Fibre Channel IP
address of the switch:
1. Login to the switch as the admin user.
2. At the command line, enter the following command:
ipAddrSet
3. An interactive session opens and prompts you for configuration
values.
a. Press ENTER without entering a value to skip over a prompt and
leave the parameter value as the default.
b. At the Ethernet IP Address prompt, enter the new IP address
for the Ethernet port on the switch. Press
ENTER to continue.
c. At the
Ethernet Subnetmask prompt, enter the address of the
subnetmask, if applicable. Press
ENTER to continue.
d. At the
Gateway Address prompt, enter the IP address of the
gateway system if applicable. Press
ENTER to continue.
e. The configuration is then committed to the switch firmware.
f. You are then prompted whether to make the IP address
changes active now or at the next reboot. Enter
y at the
prompt to have the IP address changes take effect
immediately.