Filter
Top Products
Static VLAN Configuration Screen
7-10 802.1Q VLAN Configuration Menu Screens
7.3.4 Deleting a Static VLAN
To delete a VLAN from the VLAN list, proceed as follows:
1. Use the arrow keys to highlight the line containing the
VLAN ID, FDB ID, and VLAN Name
information. The following message is displayed at the top of the screen:
“Hit <RETURN> key to edit port list, or <M> to mark.”
2. Press the M (not case sensitive) key, and an asterisk (*) appears to the left of the highlighted line.
If more than one VLAN is to be deleted, repeat steps 1 and 2 to highlight and mark each line.
Otherwise, go to step 4.
3. After the lines are marked, use the arrow keys to highlight the DEL MARKED command.
4. Press ENTER. The VLANs and marked line items are deleted from the list.
7.3.5 Paging Through the VLAN List
To display additional VLANs that do not display in the current VLAN List as shown on the screen,
use the NEXT or PREVIOUS commands located at the bottom of the screen, as follows:
1. To display the next screen, use the arrow keys to highlight NEXT. Press ENTER to view the
entries on the next screen.
2. To display the previous screen, use the arrow keys to highlight PREVIOUS. Press ENTER to
view the entries on the previous screen.
NOTE: The default VLAN cannot be deleted from the list.
NOTE: If for some reason you want to remove a mark, perform steps 1 and 2 to mark
the line. Then press M to delete the mark.
NOTE: The NEXT and PREVIOUS fields will only display if there are further VLAN List
entries to page through.