Filter
Top Products
Built-in Commands
11-34 Network Tools Screens
stpPort
Description: Enables, disables, or displays which physical ports are enabled as Spanning
Tree ports. This command does not apply to virtual interfaces such as ATM.
To enable, disable, or view the status of ATM ports, use the atm_stp_state
command.
Syntax: stpPort [status]
stpPort [enable] [port#]
stpPort [disable] [port#]
Options: status — Displays a list of the physical ports that are enabled as Spanning
Tree ports.
enable port# — Enables a specific port.
disable port# — Disables a specific port.
Examples:
-> stpPort status
The following ports are STP ENABLED:
1 2 3 4 5 6 7 8 9 10
11 12 13 14 15 16 17 18 19 20
21
-> stpPort enable 1
Enabling STP on Port 2.
-> stpPort disable 2
Disabling STP from Port 2.
stpRealTimeMsgAge
Description: Sets the BPDU MESSAGE AGE time mechanism to either IEEE or REAL
TIME.
Syntax: stpRealTimeMsgAge [ enable | disable | status ]
Options: enable – Enables the BPDU MESSAGE AGE time mechanism.
disable – Disables BPDU MESSAGE AGE time mechanism.
status – Displays the status of the BPDU MESSAGE AGE time mechanism.