Support User Manuals

Enterasys Networks 7KR4297-02 Switch User Manual

Open as PDF

of 64

Connecting to COM Port for Local Management

Matrix DFE-Platinum Series Module Installation Guide 3-13

Connecting to a VT Series Terminal

ToconnectaVTSeriesterminaltoanEnterasys NetworksDFE‐DiamondmoduleCOMport

(Figure 3‐6),useaUTPstraight‐cablewithRJ45connectorsandanoptionalRJ45‐to‐DB25female

adapter,andproceedasfollows:

1. ConnecttheRJ45connectoratoneendoftheUTPstraight‐cabletothe

COMportonthe

Enterasys Networksmodule.

2. PlugtheRJ45connectorattheotherendoftheUTPstraight‐cableintotheRJ45‐to‐DB25

femaleadapter.

3. ConnecttheRJ45‐to‐DB25adaptertotheportlabeledCOMontheVTterminal.

4. Tu rnontheterminalandaccesstheSetupDirectory.Setthe

followingparametersonyour

terminal:

Figure 3-5 Connecting an IBM PC or Compatible Device

1 UTP straight-cable with RJ45 connectors 3 RJ45-to-DB9 PC adapter

2 RJ45 COM port 4 IBM PC or compatible device

Parameter Setting

Mode 7BitControl

Transmit Transmit=9600

BitsParity 8Bits,NoParity

StopBit 1StopBit

previous next