Support User Manuals

Enterasys Networks 7KR4297-02 Switch User Manual

Open as PDF

of 64

Connecting to COM Port for Local Management

3-14 Installation

Whentheseparametersareset,theLocalManagementpasswordscreenwilldisplay.Refertothe

EnterasysMatrixDFE‐Diamond/PlatinumSeriesConfigurationGuideforfurtherinformation.

Connecting to a Modem

ToconnectamodemtoanEnterasys NetworksDFE‐DiamondmoduleCOMport(Figure 3‐7),use

aUTPstraight‐cablewithRJ45connectorsandanoptionalRJ45‐to‐DB25maleadapter,and

proceedasfollows:

1. ConnecttheRJ45connectoratoneendoftheUTPstraight‐cabletotheCOMport 

ofthe

DFE module.

2. PlugtheRJ45connectorattheotherendoftheUTPstraight‐cableintotheRJ45‐to‐DB25male

adapter.

3. ConnecttheRJ45‐to‐DB25maleadaptertothecommunicationsportonthelocalmodem.

4. Tu rnonthelocalmodem.

5. WithaPCconnectedtoaremotemodem,youcan

configuretheswitchremotely.To

accomplishthis,youmustconfigureyourPCVTemulation packagewiththefollowing

parameters:

6. Whentheseparametersareset,theLocalManagementpasswordscreenwilldisplay.Referto

theEnterasysMatrixDFE‐Diamond/PlatinumSeriesConfigurationGuideforfurtherinformation.

Figure 3-6 Connecting a VT Series Terminal

1 UTP straight-cable with RJ45 connectors 3 RJ45-to-DB25 adapter

2 RJ45 COM port 4 VT series terminal

Parameter Setting

Mode 7BitControl

Transmit Transmit=9600

BitsParity 8Bits,NoParity

StopBit 1StopBit

previous next