Support User Manuals

Enterasys Networks 7KR4297-02 Switch User Manual

Open as PDF

of 64

Completing the Installation

3-18 Installation

Figure 3-8 Matrix DFE Startup Screen Example (N7 Chassis)

Completing Installation of DFE-Diamond Module in an Existing System

InanestablishedDFE‐Diamondmodulesystem,

•aDFE‐Diamondmoduleisalreadyestablishedasthemanagementmodule,

•thepasswordshavealreadybeensetforvarioususers,

•thesystemIPaddressisset,and

•othersystemparametershavebeenset.

WhenyouinstallanewDFE‐Diamondmoduleintoasystemwithan

existingconfigureduser

account,thecurrentsystemsettingsinthataccountarealreadyrecognizedbythenew

DFE‐Diamondmoduleanditwilloperateaccordingly.

Ifyouneedtochangeanysettings,youcanconnectaterminaltothelocalconsoleportas

describedin“ConnectingtoCOMPortfor

LocalManagement”onpage 3 ‐11toaccesssystem

management,oruseaTelnetconnectiontoaccesstheDFE‐Diamondmodulesystemmanagement

asdescribedinChapter3oftheEnterasysMatrixDFE‐Diamond/PlatinumSeriesConfigurationGuide.

Logging in with an Administratively-Configured User Account

Ifthedevice’sdefaultuseraccountsettingshavebeenchanged,proceedasfollows:

1. Attheloginprompt,enteryouradministratively‐assignedusername,pressENTER.

2. AtthePasswordprompt,enteryourpassword,pressENTER.

ThenoticeofauthorizationandtheMatrixpromptdisplaysasshownbackinFigure 3 ‐8 .

login: admin

Password:

M A T R I X N7

Command Line Interface

Enterasys Networks, Inc.

50 Minuteman Rd.

Andover, MA 01810-1008 U.S.A.

Phone: +1 978 684 1000

E-mail: support@enterasys.com

WWW: http://www.enterasys.com

(c) Copyright Enterasys Networks, Inc. 2003

Chassis Serial Number: xxxxxxxxxxxx

Chassis Firmware Revision: xx.xx.xx

Matrix N7(su)->

Note: Users with Read-Write (rw) and Read-Only access can use the set password

command to change their own passwords. Administrators with Super User (su) access

can use the set system login command to create and change user accounts, and the set

password command to change any local account password. For information on the set

password and set system login commands, refer to Chapter 3 in the

Enterasys Matrix DFE-

Diamond/Platinum Series Configuration Guide

.

previous next