Filter
Top Products
Installation
EP-6VBA
Page 3-3
Easy Installation Procedure
Easy Installation Procedure
The following must be completed before powering on your new system:
3-1. Configure DIP Switch and Jumper to match your hardware
3-2. System memory Configuration
3-3. Install Pentium II or Pentium III Processor
3-4. Device Connectors
3-5 External Modem Ring-in Power ON and Keyboard Power ON
Functions (KBPO)
Section 3-1
Configure DIP Switch
We design this motherboard with a DIP Switch to make your install fast and easy.
The following will describe all of the DIP Switch that you are required to set
before moving on to step 3-2.
Note: The DIP Switch as depicted as shown (Figure 1) in their correct
physical orientation.
1
2
34
ON
1WS)zHM(UPC
1234 oitaRzHM66zHM001
NONONOX3002003
NONOX5.3332053
NONONOX4662004
NONOX5.4003054
NONOX5333005
NOX5.5663055*
NONONOX6004006*
NONOX5.6334056*
NONOX7664*007*
NOX5.7005*057*
NONOX8335*008*
*reserved
JP1 Clear COMS
1-2 : Run Mode(default)
2-3 : Clear CMOS
JP4 Keyboard Power-ON Function Selection
1-2 : Disabled
2-3 : Enabled