Filter
Top Products
BIOS
EP-6VBA
Page 4-5
Boot Sequence:
This category determines which drive is searched first by the O/S (Operating
System).
The default is A,C,SCSI.
The following is your list of options:
[A, C, SCSI] - [C, A, SCSI] - [C, CD-ROM, A] - [CD-ROM, C, A]
[D, A,CD-ROM],[E, A, CD-ROM] - [F, A, CD-ROM] - [SCSI, A, C]
[SCSI C, A] - [C Only]
Swap Floppy Drive:
This will swap your physical drive letters A & B if you are using two floppy
disks.
The default is Disabled.
Enabled: Floppy A & B will be swapped under the O/S.
Disabled: Floppy A & B will be not swapped.
Boot Up Floppy Seek:
During Power-On-Self-Test (POST), BIOS will determine if the floppy disk
drive installed is 40 or 80 tracks. Only 360K type is 40 tracks while 760K, 1.
2MB and 1.44MB are all 80 tracks.
The default is Enabled.
Enabled: The BIOS will search the floppy disk drive to determine if it is 40
or 80 tracks.
Disabled: The BIOS will not search for the type of floppy disk drive by track
number.
Note: BIOS can not tell the difference between 720K, 1.2MB and 1.
44MB drive types as they are all 80 tracks.
Boot Up NumLock Status:
This controls the state of the NumLock key when the system boots.
The default is On.
On: The keypad acts as a 10-key pad.
Off: The keypad acts like the cursor keys.