Filter
Top Products
Using Continuous Paper
See page 2-15 for instructions on loading paper with the rear-push
tractor.
To remove the tractor unit, press the tractor’s lock tabs, tilt the
unit back, and lift it off the printer.
Installing the pull-tractor
You can also use the tractor unit as a pull-tractor. To do this, you
remove the paper-tension unit and install the tractor unit in its
place. Follow the steps below to install the pull-tractor:
1.
Make sure the power is turned off. Lift the printer cover and
paper guide up and off the printer.
2.
Grasp both ends of the paper-tension unit and lift it up and
off the printer. Store the paper-tension unit in safe place.
3.
An arrow on each side of the mounting slots shows you where
to install the tractor. While pressing in the tractor’s lock tabs,
tilt the tractor unit forward and lower it straight down into the
slots.
See page 2-18 for instructions on loading paper with the pull-
tractor.
To remove the tractor unit, press the tractor’s lock tabs, tilt the
unit back, and lift it off the printer. Then replace the paper tension
unit.
Paper Handling
2-11