Filter
Top Products
68 Fine-tuning the Projector
Setting a Password
1. Press the Freeze button on the remote control for about 7 seconds
until you see the Password Protect menu:
2. Select
Password and press Enter. You see the message Change
the password?
3. Select
Yes and press Enter.
4. Hold down the
Num key on the remote control and use the
numeric keypad to enter a 4-digit password.
The password will be displayed as
****. After you enter the last
digit, a confirmation screen appears. Enter the password again.
5. After you finish setting the password, press the
Esc button to
return to the Password Protect menu.
Make a note of the password and keep it in a safe place in case you
forget it.
Turning On the Password and User’s Logo
1. Press the Freeze button on the remote control for about 7
seconds until you see the Password Protect menu.
2. To enable the password, select
Power ON Protect and press
Enter. Select ON then press Esc.
3. If you want to disable the password temporarily, select
Timer and
press
Enter. Then hold down the Num button while you use the
numeric keypad to enter the number of hours (from 0 to 9999)
that you want the password feature disabled. If you want the
projector to request the password every time it is turned on, set
the timer to
0H.
note
If a password has already
been set, you see the
Password Protect Release
screen. See “Starting the
Projector with a Password”
on page 69.
Use these buttons like a
numeric keypad to enter
the password
Hold down this button to
activate the numeric
keypad