Filter
Top Products
Selecting PostScript
For EPL-4000/4100 and ActionLaser users
1.
2.
Hold down the SelecType button for several seconds until the
display shows SelecType LEVEL2.
Press the
Aor
vbutton
until the “MODE ASSIGN” menu
appears.
3.
4.
Press the
bbutton
to enter the option; the CH submenu (for
example, $ CH P LQ
>) appears.
Press the
Aor
vbutton
to choose the interface that will use
the PostScript CARD. (If your desired interface is displayed in
step 3, ignore this step).
5.
Press the
bbutton
to enter the printer mode option. You see
the
+
icon, which means the displayed printer mode is currently
selected.
6.
Press the
Aor
vbutton
until the “0 PS” option appears.
7.
Press the
bbutton
to set the PostScript mode.
8.
Press the SelecType button three times to exit SelecType.
The PostScript mode remains in effect until you change the setting
or turn off the printer. If you wish to make this setting permanent,
use the “P-CONFIG. SAVE” menu in SelecType Level 2. See your
printer manual.
1-4
Handing the PostScript CARD