Filter
Top Products
Submenu Function
Sleep Mode
When set to On, this automatically stops projection when no
image signal is being input and no operations are carried out for a
specified length of time. Also, if no image signal is input for
approximately five minutes, the lamp dims until the power turns
off. When an image signal is input, the projector returns to
normal operating status.
Sleep Mode Tim‐
er
When Sleep Mode is set to On, you can set the time before the
projector automatically turns off within a range of 1 to 30
minutes.
Lens Cover Timer
When set to On, this turns off the power automatically 30
minutes after the lens cover is closed. Also, if the lens cover is
closed for approximately five minutes, the lamp dims until the
power turns off. When the lens cover is opened, the projector
returns to normal operating status.
A/V Mute Timer
When set to On, this turns off the power automatically 30
minutes after A/V mute is enabled. Also, if A/V mute is enabled,
the lamp dims until the power turns off. When A/V mute is
disabled, the projector returns to normal operating status.
Standby Mode
When set to Communication On, you can monitor and control
the projector from a computer, even if the projector is in standby
mode.
s "Monitoring and Controlling" p.65
ECO Display
When set to On, when the lamp brightness changes from normal
to low or low to normal, leaf icons are displayed at the bottom-
left of the projected screen to indicate the power-saving status.
Reset
You can reset all adjustment values for the ECO menu to their
default settings. See the following to return all menu items to
their default settings.
s "Reset Menu" p.88
Info Menu (Display Only)
Lets you check the status of the image signals being projected and the status
of the projector. Items that can be displayed vary depending on the source
currently being projected. Depending on the model used, some input
sources are not supported.
s "Automatically Detect Input Signals and Change the Projected Image
(Source Search)" p.31
Submenu Function
Lamp Hours
You can display the cumulative lamp operating time
*1
.
When the lamp replacement time is reached, the characters
are displayed in yellow.
Source
You can display the source name for the connected
equipment currently being projected.
Input Signal
You can display the content of Input Signal set in the
Signal menu according to the source.
Resolution
You can display the resolution.
Refresh Rate
You can display the
refresh rate
g
.
List of Functions
87