Filter
Top Products
Advanced Operations
29
Advanced Menu
Main menu Sub-menu Function
Default
setting
Advanced Progressive (Can only be adjusted for 525i and 625i image signals)
Changes signals from Faroudja's interlaced
mode to progressive (IP)
conversion mode.
•
••
•
OFF :Progressive (IP) conversion is carried out for the screens in
each field. It is designed for use when viewing images with
large amounts of movement. The DCDi function
does
not operate.
•
••
•
Video :Turns off the Film judgment function . The DCDi
function operates.
•
••
•
Film/Auto :This setting should normally be used. The projector
automatically determines whether the signal source is a
film source or not. If the source is a film source, the 3-2
pull-down function operates so that film images which
match the original are reproduced. The DCDi function
operates.
Film/Auto
Motion
Detect
(Can only be adjusted for 525i and 625i image signals)
Switches the three-dimensional Y/C separation function
and the
operating mode for progressive (IP) conversion depending on whether the
images are moving quickly or slowly.
If a lower setting is used, flickering is reduced and images become sharper
and more distinct. This mode is ideally suited for viewing still images.
If a larger setting is used, images are projected more smoothly with less
jerkiness. This mode is ideally suited for viewing moving images. Adjust to
suit the type of images being viewed.
3
Noise
Reduction
(Can only be adjusted for 525i and 625i image signals)
Reduces image interference and makes the image quality softer. Two
modes are available. Use the setting that best suits the images being
viewed. It is recommended that you set this function to OFF when viewing
images sources such as DVDs which are relatively free from interference.
OFF
Position (Adjustment is not possible when D-RGB signals are being input.)
Moves the image display position vertically and horizontally.
•
••
•
Press the [Select] on either the projector's control panel or the remote
control, and make the adjustment using the display position adjustment
screen that appears.
Depends on
connection
Video Signal (Adjustment is only possible when composite or S-Video signals are being
input.)
Sets the video signal format.
•
••
•
Press the [Select] on either the projector's control panel or the remote
control, and select the setting using the menu that appears.
•
••
•
When set to “Auto”, the video signal format is set automatically, but if
projecting signals in N-PAL format, the setting needs to be made
manually.
Auto
Input A (Can only be adjusted for 525i and 625i input signals)
Selects the type of signal being input to the Input A port.
YCbCr
Setup Level
Input B
Progressive
Motion Detect
Noise Reduction
Position
Video Signal
Input A
Reset
Execute
0% 7.5%
1 2 3 4 5
OFF NR1 NR2
Select [ Film/Auto ]
Adjust
Select
Select
Select
[ Auto ]
Video
Setting
Advanced
About
Reset All
Select
Enter
Video menu Setting menu Reset All menu
Advanced menu About menu