Filter
Top Products
Paper Handling 19
R
Loading Continuous Paper with the
Front Push Tractor
1. Make sure the printer is
turned off. Then open the
front cover and the flap.
Make sure the tractor is
installed in the front push
position. (You may need to
move it from the rear push
or pull position.)
2. Set the paper release lever to the front push tractor position.
Also set the paper-thickness lever to the proper position for
your paper’s thickness. See “Adjusting the Paper-Thickness
Setting” on page 18 for instructions.
3. Release the left and
right sprockets by
pushing the blue
lock levers
backward.
4. Slide the left
sprocket
approximately
0.5 inch (12 mm)
from the far left
position and pull the
blue lever forward to
lock it in place. Then
slide the right
sprocket to match the
width of your paper,
but do not lock it.
10
5
0