Filter
Top Products
Paper Handling 31
R
Using the Micro Adjust Function
The Micro Adjust function allows you to move the paper forward or
backward in 1/216-inch (0.118 mm) increments to adjust the tear-off and
top-of-form positions.
Adjusting the tear-off position
If your paper’s perforation is not aligned with the tear-off edge, you can
use the Micro Adjust function to move the perforation to the tear-off
position, as described below. Your tear-off position setting remains in
effect until you change it, even if you turn off the printer.
c
Caution:
Never use the knob to adjust the tear-off position; this may damage the
printer or cause it to lose the tear-off position.
1. You may need to press
the
Tear Off/Bin button to
advance the paper to the
tear-off position. Make
sure the Tear Off/Bin
light is flashing (the paper
is at the current tear-off
position).
2. Hold down the
Pause
button for about three
seconds. The Pause light
begins flashing and the
printer enters the Micro Adjust mode.