Filter
Top Products
Paper Handling 23
R
3. Release the
sprockets by
pulling the
sprocket lock
levers forward.
4. Slide the left
sprocket
approximately
0.5 inch (12 mm)
from the far left
position and push
the lever back to
lock it in place.
Then slide the
right sprocket to
match the width of
your paper, but do
not lock it.
Slide the edge guides to the center.
5. Make sure your paper has a clean, straight edge. Then open the
sprocket covers.
Note:
Make sure the printer is off before you insert the paper in the paper slot.
If you insert the paper while the printer is on, a paper jam may occur.
Edge guides