Filter
Top Products
38 Using the Control Panel
L
Changing the Printer’s Default Settings
While you can often change the printer’s settings through your software
or printer driver, you may sometimes need to change one or more of the
printer’s default settings. There are two ways to do this:
❏ Using the EPSON Remote Configuration Manager on the printer
software CD-ROM. (See page 15.)
❏ From the printer’s control panel using the default-setting mode.
For instructions on using the Remote Configuration Manager, see the
PDF manual on the CD-ROM. To use the control panel, see below. For
detailed information about default settings, see the Reference Guide. The
following table shows the options available for each printer setting.
Setting Options (default in bold)
Page length for front
tractor
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, 11, 70/6, 12,
14, 17
Page length for rear
tractor
Length in inches: 3, 3.5, 4, 5.5, 6, 7, 8, 8.5, 11, 70/6, 12,
14, 17
Skip over perforation Off, On
Auto tear-off Off, On
Auto line feed Off, On
Print direction Bi-D, Uni-D
Software ESC/P, IBM PPDS
0 slash 0,
I/F (interface) mode Auto, Parallel, USB, Option
Auto I/F wait time 10 seconds, 30 seconds
Parallel I/F bidirectional
mode
Off, On
Packet mode Auto, Off
Character table Italic, PC 437, PC 850, PC 860, PC 863, PC 865, PC 861,
BRASCII, Abicomp, Roman 8, ISO Latin 1, PC 858,
ISO 8859-15
International character
set for italic table
Italic U.S.A., Italic France, Italic Germany, Italic U.K.,
Italic Denmark 1, Italic Sweden, Italic Italy, Italic Spain 1
Manual feed wait time 1 second, 1.5 seconds, 2 seconds, 3 seconds
Buzzer Off, On