Filter
Top Products
5
Using an Optional Interface Card
5-3
R4C5980
Rev. C
A5 size CARD.FM
7/12/01 Pass 3
R
Proof Sign-off:
DAI A. Kobayashi T. Morita
K. Nishi
DAI K. Ramsey
4. Use a cross-head screwdriver to remove the two screws
securing the shield plate to the optional interface slot; then lift
off the plate. Be sure to keep the screws; you may need to use
them again when you re-install the shield plate.
5. Slide the interface card along the slots on both sides of the
interface compartment. Push it in firmly to fully insert the
connector at the rear of the interface card into the printer’s
internal socket.
6. Secure the interface card in the slot with the two screws
included with the interface card.
7. Connect a compatible interface cable to the interface card and
to your computer. If the cable has a ground wire, secure it with
one of the screws.
Also, if you are using more than one computer, reconnect the
other interface cable.
8. Make sure the printer is turned off. Then plug in the power
cord.
To remove an interface card, follow the above steps in reverse
order.