Filter
Top Products
Initialization
By observing the scanner’s initialization, you can make sure the
scanner is operating properly before you connect it to your
computer.
1.
Open the document cover so you can see the operation of
the scanner during initialization.
2.
Turn on the scanner by pressing the
OPERATE
button.
While the scanner is initializing, the fluorescent lamp on the
carriage flashes. If the carriage is not at the home position (the
rear of the scanner), it moves to the home position.
When the scanner has completed its initialization, the
READY
light comes on. If the scanner does not work as described, turn
it off. Make sure that the power cord is firmly plugged in and
that the transportation lock lever is in the
UNLOCK
position.
Then turn on the scanner and check its operation again.
Connecting the Scanner to Your Computer
Your scanner has both a bidirectional parallel interface and a
SCSI interface. Cables can be connected to both interfaces at the
same time. The scanner automatically switches to the
appropriate interface.
0
To connect the scanner to a PC, do one of the following:
Install a bidirectional parallel interface board in your
computer, if necessary. Then connect the computer to the
scanner’s bidirectional interface as described in the next
section.
Setting Up the Scanner
1-5