Filter
Top Products
Using the termination switch
The scanner has a built-in SCSI terminator. If the scanner is the
only SCSI device you connect to your computer or if it is the
last device in the daisy chain, leave the termination switch
turned on.
If the scanner is in the middle of a daisy chain, turn off the
termination switch.
Connecting the scanner to your computer or to another
SCSI device
To connect the scanner to a Macintosh, use a SCSI cable with a
25-pin connector on one end (for the computer) and a 50-pin
connector on the other end (for the scanner). To connect the
scanner to a PC or another SCSI device, use a SCSI cable with
50-pin connectors on both ends. Connect the scanner as
follows:
1.
Make sure that the scanner, the computer, and all other SCSI
devices are turned off and unplugged from the power
source.
1-10
Setting Up the Scanner