Filter
Top Products
1.
Locate the SCSI ID rotary switch on the rear panel of the
scanner.
2.
To change the scanner’s SCSI ID, turn the dial to the desired
number.
Caution:
Do not set the scanner’s SCSI ID to a number that is
already assigned to another device; the computer, scanner,
and other devices will not function properly.
Note:
If your software supports only the ES-1200C scanner, set the dial
to the position marked
*
to select ES-1200C Emulation mode. In
ES-1200C Emulation mode, the scanner’s SCSI ID number is 2.
If one of your other SCSI devices already has the SCSI ID
number 2, change that device’s number to an unused number.
Setting Up the Scanner
1-9