Filter
Top Products
2
Paper Handling 2-31
R4C4590
Rev. C
A5 size HANDLE.FM
10/30/00 Pass 1
R
Proof Sign-off:
Takahashi, Kono _______
Takahashi _______
Hoadley _______
Adjusting the tear-off position
If your continuous paper perforation is not aligned with the tear-
off edge, you can use the micro-adjust feature to move the
perforation to the tear-off position as follows:
1. Make sure both
Tear Off
lights are flashing (the paper is at
the current tear-off position). You may need to press the
Tear
Off
button. (See “Using the Tear Off button” on page 2-15 for
more information.)
2. Hold down the
Pause
button for about three seconds. The
Pause
light begins flashing and the printer enters the micro-
adjust mode.
3. Press the
LF/FF
[
D] button to feed paper forward, or press the
Load/Eject
[
U] button to feed paper backward, until the
paper perforation is aligned with the tear-off edge.
Note:
The printer has a minimum and a maximum tear-off position. If you
try to adjust the tear-off position beyond these limits, the printer
beeps and stops moving the paper.