Filter
Top Products
Solving Problems
39
Problems and Solutions
Setup and Software
Installation Problems
The printer makes noise after ink
cartridge installation.
■
The first time you install ink
cartridges, the printer must charge
its print head for a few minutes.
Wait until charging finishes (the
green
P power light stops flashing)
before you turn off the printer, or it
may charge improperly and use
excess ink the next time you turn it
on.
If the printer stops moving or
making noise, but the green
P power light is still flashing after 5
minutes, turn off the printer. If the
light is still flashing when you turn it
back on, contact EPSON as
described on page 47.
■
Make sure the ink cartridge clamps
are locked down completely and no
packing material remains in the
printer. Turn off the printer, wait a
moment, then turn it back on to
clear the error.
You’re having problems installing the
printer software.
■
Make sure your printer is turned on
and the printer cable is securely
connected at both ends. Then
carefully follow the installation
instructions on the Start Here sheet.
Also make sure your system meets
the requirements on pages 49
and 50.
■
Close your other programs,
including any screen savers and virus
protection software, and install
again.
■
If your printer icon (
C60 Series
)
doesn’t appear in the Macintosh
Chooser, you may have too many
items in the Chooser. Delete any
unused items and check the Chooser
again.
■
For Windows 2000, if you see an
error message or your software
doesn’t install correctly, you may not
have software installation privileges.
Contact your System Administrator.