Filter
Top Products
Introduction 17
Inside - S30675
Dirt on any of the following parts may reduce print quality. Regularly clean or exchange
these parts as described in the chapters listed in the reference sections below.
1 Print head
The print head prints by moving left and right while emitting ink. We recommend that you clean the area around this unit at
the end of each workday. Make sure the print head is at the far left side of the printer before cleaning.
See “Cleaning Around the Print Head (Daily)” on page 137.
2 Media holding plate (edge guide)
The media holding plates prevent the media riding up and keeps fibers on the cut edge of the media from touching the print
head. Position the plates at either side of the media before printing.
See “Loading Media - S30675” on page 65.
3Cutter groove
Pass the blade of a cutter (not included) down this groove to cut media.
4 Pressure rollers
These rollers press down on the media during printing.
See “Cleaning Inside the Printer (Daily)” on page 155.
5 Platen heater
The platen heater ensures that the ink adheres evenly.
See “Heating & Drying” on page 114.
See “Cleaning Inside the Printer (Daily)” on page 155.
6 Wiper cleaner
The wiper cleaner removes ink from the wiper. It is included in the maintenance kit and needs to be replaced about once every
three months (or more often, depending on usage).
See “Cleaning the wiper cleaner and wiper rail (daily)” on page 148.