Filter
Top Products
Maintenance 198
Buttons that are used in the following settings:
1. Remove any paper from the printer.
See “Removing the roll paper” on page 41, “Removing Cut Sheets” on page 46, or
“Removing Poster Board” on page 52.
2. Confirm that the printer is ready to print. Press the l/r buttons to highlight - and press
the OK button.
The Maintenance menu will be displayed.
3. Press the d/u buttons to highlight Cutter Maintenance and press the OK button.
4. Press the d/u buttons to highlight Replace Cutter and press the OK button.
5. The cutter will move to the replacement position.
6. Remove the old cutter from the printer.
Loosen the screw holding the cutter in place using a cross-head screwdriver and pull
the cutter straight out.