Filter
Top Products
Basic Operations 47
Loading and Removing Poster Board
This section describes how to load and remove poster board from 0.9 to 2.1 mm thick.
The printer can be used with board of the following sizes.
A2/A1/B2/B1
*
/B1 landscape
*
/24 × 30 inch/30 × 40 inch
*
* Not supported by the SureColor T3000.
Loading Poster Board
Poster board requires space both behind and in front of the printer. The approximate
amount of space required is shown below. If the printer is set up near a wall, make sure
there is enough space at the rear.
Paper Size Front (a) Back (b)
A2 17.5 inches (444 mm) 5.3 inches (135 mm)
A1 27.2 inches (691 mm) 15 inches (382 mm)
B2 22.7 inches (578 mm) 10.6 inches (269 mm)
B1 34.6 inches (880 mm) 22.5 inches (571 mm)
24 × 30 inch 24.1 inches (612 mm) 11.9 inches (303 mm)
30 × 40 inch 34.1 inches (866 mm) 21.9 inches (557 mm)
Important:
Insert the paper just before printing. The roller may leave an impression on paper that is left in
the printer.
Note:
The paper that can be used in the printer is detailed in the following section. See “Supported
Media” on page 223.