Filter
Top Products
5-2 Commands
Control Commands
HT
[Name] Horizontal tab
[Format] ASCII HT
Hex 09
Decimal 9
[Description] Moves the print position to the next horizontal tab position.
[Notes] • This command is ignored unless the next horizontal tab position
has been set.
• If the next horizontal tab position exceeds the printing area, the
printer sets the printing position to [Printing area width + 1].
• Horizontal tab positions are set with
ESC D
.
• If this command is received when the printing position is at
[printing area width + 1], the printer executes print buffer-full
printing of the current line and horizontal tab processing from the
beginning of the next line.
[Reference]
ESC D
LF
[Name] Print and line feed
[Format] ASCII LF
Hex 0A
Decimal 10
[Description] Prints the data in the print buffer and feeds one line based on the
current line spacing.
[Note] This command sets the print position to the beginning of the line.
[Reference]
ESC 2
,
ESC 3
FF
[Name] Print and return to standard mode (in page mode)
[Format] ASCII FF
Hex 0C
Decimal 12
[Description] Prints the data in the print buffer collectively and returns to standard
mode.
[Notes] • The buffer data is deleted after being printed.
• The printing area set by
ESC W
is reset to the default setting.
• The printer does not execute paper cutting.
• This command sets the print position to the beginning of the line.
• This command is enabled only in page mode.
[Reference]
ESC FF, ESC L, ESC S