Filter
Top Products
Commands 5-23
• This command switches the settings for the following commands
(in which the values can be set independently in standard mode
and page mode) to those for standard mode:
➀
Set right-side character spacing: ESC SP
➁
Select 1/6-inch line spacing: ESC 2
➂
Set line spacing: ESC 3
[Reference] FF, ESC FF, ESC L
ESC T
n
[Name] Select print direction in page mode
[Format] ASCII ESC T
n
Hex 1B 54
n
Decimal 27 84
n
[Range] 0
≤
n
≤
3
48
≤
n
≤
51
[Description] Selects the print direction and starting position in page mode.
n
specifies the print direction and starting position as follows:
[Notes] • When the command is input in standard mode, the printer
executes only internal flag operation. This command does not
affect printing in standard mode.
• This command sets the position where data is buffered within the
printing area set by ESC W.
• Parameters for horizontal or vertical motion units
(
X
or
y
)
differ as
follows, depending on the starting position of the printing area
:
➀
If the starting position is the upper left or lower right of the
printing area, data is buffered in the direction perpendiccular to
the paper feed direction:
Commands using horizontal motion units: ESC SP, ESC $,
ESC \
Commands using vertical motion units: ESC 3, ESC J, GS $,
GS \
n
Print Direction Starting Position
0, 48 Left to right
Upper left
(A in the figure)
1, 49 Bottom to top
Lower left
(B in the figure)
2, 50 Right to left
Lower right
(C in the figure)
3, 51 Top to bottom
Upper right
(D in the figure)
A
D
C
B
Printing area
Paper feed direction