Filter
Top Products
Commands 5-41
Decimal 29 73
n
[Range] 1
≤
n
≤
3, 49
≤
n
≤
51
[Function] Transmits the printer ID specified by
n
as follows:
n
= 2, Type ID
[Notes] • When DTR/DSR control is selected, the printer transmits only 1
byte after confirming that the host is ready to receive data (DSR
signal is SPACE). If the host computer is not ready to receive data
(DSR signal is MARK), the printer waits until the host is ready.
• When XON/XOFF control is selected, the printer transmits only 1
byte without confirming the condition of the DSR signal.
• The printer ID is transmitted when the data in the receive buffer is
developed. Therefore, there may be a time lag between receiving
this command and transmitting the status, depending on the
receive buffer status.
• The ROM version may be changed.
• When Auto Status Back (ASB) is enabled using GS a, the status
transmitted by GS I and the ASB status must be differentiated.
GS L
n
L
n
H
[Name] Set left margin
[Format] ASCII GS L
nL nH
Hex 1D 4C
nL nH
Decimal 29 76
nL nH
n
Printer ID Specification ID (hexadecimal)
1, 49 Printer model ID TM-T85/T85P 08H
2, 50 Type ID See table below.
3, 51 ROM version ID Depends on ROM version
Bit Off/On Hex Decimal Function
0 Off 00 0 Two-byte character code not supported.
1 On 02 2 Auto-cutter equipped.
2 - - - Undefined.
3 - - - Undefined.
4 Off 00 0 Not used. Fixed to Off.
5 - - - Undefined.
6 - - - Undefined.
7 Off 00 0 Not used. Fixed to Off.