Filter
Top Products
5-8 Commands
• The horizontal and vertical motion unit are specified by GS P.
Changing the horizontal or vertical motion unit does not affect the
current right-side spacing.
• The horizontal and vertical motion unit are specified by GS P.
Changing the horizontal or vertical motion unit does not affect the
current right-side spacing.
•The GS P command can chahge the horizotal (and vertical)
motion unit. However, the value cannot be less than the minimum
horizontal movement amount, and it must be in even units of the
minimum horizontal movement amount.
• In standard mode, the horizontal motion unit is used.
• In page mode, the horizontal or vertical motion unit differs in
page mode, depending on starting position of the printable area as
follows:
1 When the starting position is set to the upper left or lower right
of the printable area using ESC T, the horizontal motion unit (
x
)
is used.
2 When the starting position is set to the upper right or lower left
of the printable area using ESC T, the vertical motion unit (
y
) is
used.
• The maximum right-side spacing is 255/180 inches. Any setting
exceeding the maximum is converted to the maximum
automatically.
[Default]
n
= 0
[Reference] GS P
ESC !
n
[Name] Select print mode(s)
[Format] ASCII ESC !
n
Hex 1B 21
n
Decimal 27 33
n
[Range] 0
≤
n
≤
255
[Description] Selects print mode(s) using
n
as follows:
Bit Off/On Hex Decimal Function
0
Off 00 0 Character font A( 12
✕
24) selected.
On 01 1 Character font B (9
✕
24) selected.
1 - - - Undefined.
2 - - - Undefined
3
Off 00 0 Emphasized mode not selected.
On 08 8 Emphasized mode selected.