Filter
Top Products
Epson STYLUS NX100/NX105/SX100/SX105/TX100/TX101/TX102/TX103/TX105/TX106/TX109/ME 300 Revision A
TROUBLESHOOTING Error Indications and Fault Occurrence Causes 42
Confidential
• Operation
•–
The LD Roller is not set to the ASF home
position and paper is always loaded from
the ASF Unit during the paper loading
sequence.
ASF Unit
1. Check if the tip of the Change Lever is damaged. 1. Replace the Change Lever with a new one.
Table 3-6. Check point for Double feed error according to each phenomenon
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point Remedy
• Operation
•–
After both surfaces were printed, the
paper was ejected but an error is
displayed.
ASF Unit
1. Check if the Extension Spring operates correctly in the
paper loading sequence.
1. Set the Extension Spring between the Retard
Roller Assy and the ASF Housing.
2. Check if the Paper Back Lever operates correctly in the
paper loading sequence.
2. Set the Extension Spring between the ASF
Housing and the Paper Back Lever.
Table 3-5. Check point for Paper out error according to each phenomenon
Occurrence
timing
CR position
Detailed phenomenon
Defective
unit/part name
Check point Remedy
Extension Spring
Backside of ASF Unit
Paper Back Lever
Extension Spring