Filter
Top Products
3-25CrossPoint 300 Matrix Switchers • Operation
Example 8: Viewing and adjusting an input audio level
The following steps show an example in which an audio level is viewed and
adjusted. The steps show the front panel indications that result from your actions.
Audio gain and attenuation is displayed differently on different models. See the
table on page 3-26.
• Switchers with 16 output LEDs — Each output LED indicates 1 dB when
blinking and 2 dB when lit.
• Switchers with 8 output LEDs — Each output LED indicates 1 dB when
blinking slowly, 2 dB when blinking quickly, and 3 dB when lit.
For this reason, figure 3-45 and figure 3-47 show the indications displayed on a
switcher with 16 output buttons without duplicating all of the actions shown in
figure 3-44 and figure 3-46, which show switchers with 8 output buttons.
1. Press and release the Esc button (figure 3-42).
ENTER PRESET VIEW ESC
CONTROL
P
ress the Esc button to clear all selections.
The LED
blinks once
.
Figure 3-42 — Clear all selections
2. Press and hold the Audio button for approximately 2 seconds until the Audio
LED blinks (figure 3-43).
R
GBHV AUDIO AUDIO
I/O
The LED blinks to indicat
e
Audio mode.
Release the button.
Press and hold
the Audio button.
2 seconds
Figure 3-43 — Select Audio mode