Extron electronic 1616 Switch User Manual


 
Matrix Software, cont’d
CrossPoint 300 Matrix Switchers Matrix Software5-2
Matrix Software
Matrix Switchers Control Program
The Windows-based Extron Matrix Switchers Control Program communicates with
the switcher via the rear panel Remote RS-232/RS-422 port and the front panel
Configuration (RS-232) port to provides an easy way to set up ties and sets of ties.
The program is compatible with Windows 2000 and Windows XP.
Installing the software
The program is contained on the Extron Software Products CD-ROM, disk B.
Install the software as follows:
For full functionality, install both of the following programs:
The Matrix Switchers Control Program
The Firmware Loader
1. Insert the CD-ROM into the drive. The installation program should start
automatically. If it does not self-start, run Launch.exe from the CD.
The Extron software CD window appears (figure 5-1).
Figure 5-1 — Software CD window
2. Click the Software tab (figure 5-1).
3. Scroll to the desired program and click Install (figure 5-2).
Figure 5-2 — Software installation