Filter
Top Products
6 XTP CrossPoint 1600 and 3200 • Installation 7XTP CrossPoint 1600 and 3200 • Installation
Inputs and Outputs
a
Input boards space — Make connections to installed input boards
as desired.
XTP CP 4i (XTP input board)
IN
IN
XTP CP 4i
RS-232 IR
Tx Rx TxRx
RS-232 IR
Tx Rx TxRx
RS-232 IR
Tx Rx TxRx
RS-232 IR
Tx Rx TxRx
SIG LINK
XTP
PWR
LAN
XTP
PWR
LAN
XTP
PWR
LAN
XTP
PWR
LAN
IR/RS-232 OVER XTP
SIG LINK SIG LINK SIG LINK
1b1b 1b1b 1d1a 1a1a 1a 1c 1c1c 1c
1a
XTP input connectors — Connect a TP cable
XTP
PWR
SIG LINK
between a compatible Extron XTP transmitter and
this connector (see TP connectors on page 12 to
wire the connectors).
ATTENTION: Do not connect this device to a computer data
or telecommunications network.
1b
XTP Power indicators — Light or blink to indicate the status
of the power over XTP that the input board is providing to the
transmitter endpoint as follows:
Lit green — The board is providing XTP power to the endpoint.
Lit amber — XTP Power is available for the endpoint, but it is
disabled in the matrix switcher.
Flashing amber — No XTP power is available for the endpoint,
but it is enabled in the matrix switcher.
Lit red — A wiring fault exists.
Unlit — The endpoint is not capable of receiving power over XTP.
1c
LAN connectors — As desired, connect a TP cable
LAN
between a host device or control LAN and this
connector for passive extension to the LAN (Ethernet)
connector on the connected endpoint (see TP
connectors on page 12 to wire the connector).
1d
RS-232/IR Over XTP connectors — If desired,
RS-232 IR
TxRx TxRx
connect serial RS-232 signals, modulated IR signals,
or both to these 3.5 mm, 5-pole captive screw
connectors for bidirectional RS-232 and IR communications on
the associated inputs. (see RS-232 and IR connectors on
page 13 to wire the connectors).
Figure 3. Active Portion of XTP CrossPoint 3200 Switcher Rear Panel
XTP CP 4i HDMI (HDMI input board)
IN
XTP CP 4i HDMI
AUDIO
LR LRLR LR
IN
1e1e 1e1e 1f
1e
HDMI connectors — Connect up to four HDMI cables
between these ports and the HDMI output port of the
digital video sources.
NOTE: See HDMI connectors on page 14 to secure the
connector to the board with a LockIt HDMI Cable Lacing
Bracket.
1f
Audio (local audio) connectors — Connect
LR
balanced or unbalanced stereo audio inputs to these
3.5 mm, 5-pole captive screw connectors (see Local
audio connectors on page 15 to wire the connectors).
LAN
ACT
LINK
RESET
100-240V
50-60Hz
--A MAX
REMOTE
RS 232/RS422
DISCONNECT POWER
CORD BEFORE
SERVICING
I
N
P
U
T
S
O
U
T
P
U
T
S
4
1 2
3
6
5