Filter
Top Products
8 XTP CrossPoint 1600 and 3200 • Installation 9XTP CrossPoint 1600 and 3200 • Installation
XTP CP 4i DVI Pro (DVI Pro input boards)
IN
XTP CP 4i DVI Pro
AUDIO
LR LRLR LR
IN
1g1g 1g1g 1h
1g
DVI connectors — Connect up to four DVI
cables between these ports and the DVI
output port of the digital video sources.
1h
Audio (local audio) connectors — Connect
LR
balanced or unbalanced stereo audio inputs to these
3.5 mm, 5-pole captive screw connectors (see Local
audio connectors on page 15 to wire the connectors).
XTP CP 4i VGA (Universal analog video input boards)
IN
XTP CP 4i VGA
AUDIO
LR LRLR LR
IN
1i1i 1i1i 1j
1i
VGA connectors — Connect up to four VGA
cables between these ports and the analog
audio output port of the video sources.
NOTE: These universal analog video boards can accept RGB
video and (with adapters) component video, S-video, and
composite video (see Analog video connectors on page 15
to wire the connectors for various analog video formats).
1j
Audio (local audio) connectors — Connect
LR
balanced or unbalanced stereo audio inputs to these
3.5 mm, 5-pole captive screw connectors (see Local
audio connectors on page 15 to wire the connectors).
b
Output boards space — Make connections to installed output
boards as desired.
XTP CP 4o (XTP output board)
OUT
XTP CP 4o
RS-232 IR
Tx Rx TxRx
RS-232 IR
Tx Rx TxRx
RS-232 IR
Tx Rx TxRx
RS-232 IR
Tx Rx TxRx
SIG LINK
XTP
PWR
LAN
XTP
PWR
LAN
XTP
PWR
LAN
XTP
PWR
LAN
IR/RS-232 OVER XTP
SIG LINK SIG LINK SIG LINK
OUT
2b2b 2b2b 2d2a 2a2a 2a 2c 2c2c 2c
2a
XTP output connectors — Connect a TP cable
XTP
PWR
SIG LINK
between this connector and a compatible Extron
XTP receiver (see TP connectors on page 12 to
wire the connector).
2b
XTP Power indicators — Light or blink to indicate the status
of the power over XTP that the output board is providing to the
receiver endpoint as follows:
Lit green — The board is providing XTP power to the endpoint.
Lit amber — XTP Power is available for the endpoint, but it is
disabled in the matrix switcher.
Flashing amber — No XTP power is available for the endpoint,
but it is enabled in the matrix switcher.
Lit red — A wiring fault exists.
Unlit — The endpoint is not capable of receiving power over XTP.
2c
LAN connectors — As desired, connect a TP cable
LAN
between a host device or control LAN and this
connector for passive extension to the LAN (Ethernet)
connector on the connected endpoint (see TP
connectors on page 12 to wire the connector).
2d
RS-232/IR Over XTP connectors — If desired,
RS-232 IR
TxRx TxRx
connect serial RS-232 signals, modulated IR signals,
or both to these 3.5 mm, 5-pole captive screw
connectors for bidirectional RS-232 and IR
communications on the associated inputs (see RS-232 and IR
connectors on page 14 to wire the connectors).