Extron electronic MAV 48 Switch User Manual


 
2-3MAV 44 / 48 / 84 / 88 Matrix Switchers • Installation
#
8 Screw (4 Plcs)
E
ach Side
Mounting Screws (2 Plcs)
Each Side
or
100-240V 0.3A
IN
OUT
SYNC
RS 232
3
4
5
6
7
8
1
2
1
2
3
4
5
6
7
8
INPUTS
OUTPUTS
INPUTS
MAV 88 AV
OUTPUTS
L
R
7
L
R
8
L
R
5
L
R
6
L
R
3
L
R
4
L
R
1
L
R
2
L
R
7
L
R
8
L
R
5
L
R
6
L
R
3
L
R
4
L
R
1
L
R
2
50-60Hz
Rack-mount
Bracket
(Included)
Table/
Wall-mount
Bracket (Optional)
Drill pilot holes
3/32” (2 mm) dia
.,
1/4” (6 mm) dee
p.
Figure 2-1 — Mounting the switcher
Furniture mounting the switcher
The MAV Series switcher models can be mounted under a table or other horizontal
surface with an optional Extron under-desk mounting kit (part #70-222-01).
1. Secure the two table/wall mounting brackets to the switcher with the eight
machine screws provided in the kit (figure 2-1).
2. Hold the switcher with attached brackets against the underside of the desk or
other furniture. Mark the location of holes for screws on the underside of the
desk.
3. Drill 1/4" (6.4 mm) deep, 3/32" (2 mm) diameter pilot holes in the table or
desk at the marked screw locations from the underside/inside (concealed
side) of the furniture, where the switcher will be located.
4. Insert the four wood screws into the pilot holes. Fasten each screw into the
installation surface until just less than 1/4" of the screw head protrudes.
5. Align the installed screws with the slots in the mounting brackets, and place
the switcher against the surface, with the screws through the bracket slots.
6. Slide the switcher slightly forward or back, then tighten all four screws to
secure it in place.