Filter
Top Products
VersaTools
®
MTP Series • Installation
VersaTools
®
MTP Series • Installation
Installation, cont’d
2-6
Setting the jumpers on AAP transmitters
1. Remove and retain the two screws that secure the back
cover to the MTP (figure 2-5).
12V
0.5A MAX
OUTPUT
POWER
− +
1. Remove these screws.
2. Carefully pull RJ-45 connector
through this hole.
Figure 2-5 — Removing the MTP cover
2. Pull the cover out of the way, carefully twisting the RJ-45
connector as necessary to slide it through the hole in the
cover marked “Output”.
3. Remove and retain the two standoffs that secure the audio
board to the main (video) board (figure 2-6). Lift the audio
board out of the way.
Remove these standoffs.
Figure 2-6 — Removing the audio board
2-7
4. Locate the jumper block (figure 2-7) on the video board.
Shift the jumper to the alternate location.
Mono (default jumper position)
Compatible with new model receivers.
Cannot remotely power receiver
Stereo
Compatible with old model receivers.
Can remotely power receiver.
Figure 2-7 — Video board jumper locations
5. Replace the audio board and secure it in place with the
standoffs removed in step 3.
6. Feed the RJ-45 connector through the hole in the cover
marked “Output” and replace the cover. Secure the cover
in place with the two screws removed in step 1.
CAUTION
Ensure that the TP cable is not pinched when you
reinstall the cover.