Extron electronic SW YUV A Switch User Manual


 
Introduction, cont’d
SW RGB and YUV A Switchers • Introduction1-4
All models
Bandwidth — Bandwidth is 350 MHz (-3 dB). This high bandwidth allows the
switchers to switch all of the high-resolution video signals with no loss of
signal quality.
Input signal sensing — The switcher continuously monitors all inputs to sense
when the input signal is active or inactive. The switcher reports changes in
the status of each input (active to inactive or inactive to active) on the RS-232
port.
Autoswitching mode — When autoswitching is enabled, the switcher continuously
monitors all inputs and automatically switches to the highest-numbered
input with video sync pulses present. If video is absent from all inputs, no
input is selected.
Operational flexibility — The operator can select the input and set the audio gain
and attenuation for each input using the front panel buttons or via the
switcher’s Remote port RS-232 link. The RS-232 link allows remote control
via a PC or control system. The operator can select inputs via the switcher’s
contact closure link on the Remote port. The operator can also remotely
control the switchers using a contact closure keypad connected to the Remote
port or an Extron IR 102 Universal remote control kit (part #70-224-01)
connected to the Remote port.
Rack mount — Rack mountable in any conventional 19" wide rack with the
supplied rack ears. The two SW2 models require an optional 1U Universal
Rack Mount Kit (part #60-190-01) for rack mounting.
Power supply — Includes an internal 100 VAC to 240 VAC, 50/60 Hz, 20 watts,
auto-switchable power supply, which provides worldwide power
compatibility.