Filter
Top Products
Installation, cont’d
SW RGB and YUV A Switchers • Installation2-6
5. Slide the switcher up and down or back and forth in the mounting brackets until the face of
the switcher is at the desired height. Tighten the screws that secure the bracket in place.
If the screws are inaccessible to a screwdriver:
a. Mark the location of the brackets relative to the screws.
b. Remove the switcher from the underside of the surface.
c. Tighten the screws.
d. Replace the switcher on the underside of the surface (step 4).
Cabling and Rear Panel Views
All connectors are on the rear panel. The switcher can be connected to up to six
RGBHV or component video devices and (audio models only) stereo audio devices,
depending on the model. All switcher models output the identical video and/or
audio output as the selected input. The switchers perform no sync or video format
manipulation.
SW 2 models are in half-rack width enclosures and the rest of the models are in full-
rack width enclosures. Figure 2-5 shows an SW2 RGBHV video switcher.
Figure 2-6 shows an SW4 RGBHV A video and audio switcher. Figure 2-7 shows an
SW6 YUV A component video and audio switcher. The three switchers shown have
all of the connector configurations that are available in the SW RGB and SW YUV A
product family covered in this manual.
Switchers with video capabilities can switch video and audio separately (audio
breakaway).
AUTO
MANUAL
REMOTE
100-240V 1.3A
INPUT 1
INPUT 2
R G
B
H/HV
V
50-60Hz
V
OUTPUT
R
G
B
H/HV
8
4
7
1
Figure 2-5 — SW2 RGBHV video switcher
100-240V 1.3A
50-60Hz
REMOTE
AUTO
MANUAL
INPUTS
LR
LR
3
4
OUTPUT
OUTPUT
V
R
G
B
H/
HV
2
1
LR
LR
LR
INPUT 1
INPUT 2
RG
B
H/HV
V
INPUT 3
INPUT 4
RG
B
H/HV
V
8
5
4
1
7
2
Figure 2-6 — SW4 RGBHV A switcher with audio
100-240V 1.3A
50-60Hz
INPUT 1
INPUT 2
REMOTE
AUTO
MANUAL
INPUT 3
INPUT 4
INPUT 5
INPUT 6
OUTPUT
R-Y
Y
B-Y
Digital Audio
R-Y
Y
B-Y
Digital Audio Digital Audio
R-Y
Y
B-Y
R-Y
Y
B-Y
Digital Audio
1 3 1 3 1 3 4
6
8
7
Figure 2-7 — SW6 YUV A component video switcher with audio